Before use
Do not place the devices near sources of interference such as television sets,
computers, thick walls, thermopane windows etc. Otherwise the transmission
of radio waves between the devices may be impaired.
Please ensure that neighbouring devices are not operated at the same frequency
of 433 MHz. Such devices may cause interference to the radio connection.
Do not place the devices next to or on metal plates. Otherwise the quality of
radio wave transmission may be reduced.
Do not install the devices in buildings made of reinforced concrete, e.g. airports,
high-rise buildings, factories or cellars. Otherwise the transmission of the radio
waves between the devices may be severely impaired.
In open spaces do not place the devices more than 30 metres apart, as otherwise
transmission of the radio waves may be interrupted. Otherwise the quality of
radio wave transmission may be interrupted.
Preparing to use the outdoor sensor
Remove the battery compartment cover from the back of the outdoor sensor.
Remove the battery safety strip. The outdoor sensor is now ready for operation
and the control LED
41
lights up briefly.
Note: If you use more than one outdoor sensor (max. 3), you can receive data
at the weather station from all the individual outdoor sensors. Set a different
channel for each of the sensors using the channel selector switch
44
.
Close the battery compartment cover.