■ 8
│
GB
SKM 550 B1
After you have finished
using your appliance
1) Switch the appliance off using the rotary
switch ..
2) Set the rotary switch . to P and hold it in
this position until the drive unit 6 comes to a
standstill (Image B).
3) Remove the lid.
4) Press down the release button ! and move
the pivot arm 0 into operating position 4.
5) Remove the attachment you have been using
from the drive unit 6.
6) Remove the mixing bowl .
7) Clean the appliance (see section “Cleaning
and care”).
Working with
the continuous shredder
WARNING! RISK OF INJURY!
► To avoid personal injury and damage to the
appliance, never insert or place your hands
or any foreign objects into the feed tube.
► Always use the pusher and no other implement
or body part to push ingredients into the
appliance. Danger of injury due to rotating
parts!
► Switch from one accessory to another only
when the drive unit 6 is at a complete stand-
still! After being switched off, the drive unit 6
will continue to run for a short time.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
NOTE
► The appliance may only be used when the
drive hubs not being utilised are fitted with
their protective covers.
► Make sure that neither the kneading hooks ,
the whisk , or the beater are attached
to the pivot arm 0.
Proceed as follows to prepare the appliance for
operation using the continuous shredder :
1) Press down the release button ! and move
the pivot arm 0 into operating position 4
(see the section “Operating positions”).
2) Set the mixing bowl into place. The base
of the mixing bowl must click into the re-
cesses 1 on the appliance.
3) Press down the release button ! and move
the pivot arm 0 into operating position 2.
4) Remove the protective cover from the drive
for the continuous shredder (Image C).
5) Insert the continuous shredder into the
hub socket (aligning the marking “
” on the
continuous shredder with the marking “ ”
on the pivoting arm 0).
Turn it in an anti-clockwise direction until the
continuous shredder clicks firmly in place
(and the marking “ ” on the continuous shred-
der is aligned with the marking “ ” on
the pivoting arm 0).
6) Set the drive shaft into place.
7) Depending on the task you want to perform,
place the cutting -, shredding or grating
disc onto the drive shaft of the continous
shredder .
8) Place the lid with the pusher 3 onto the con-
tinuous shredder (so that the marking “
”
on the lid 3 is lined up with the marking “ ”
on the continuous shredder ) and lock the
lid in (marking “ ” on the lid 3 is lined
up with the marking “ ” on the continuous
shredder ).
9) Turn the rotary switch . to the required setting.
NOTE
► Do not press too much food into the continuous
shredder . Take note of the table in the sec-
tion "Recommended filling levels".
10) Add the ingredients through the opening in the
lid with the help of the pusher.