Troubleshooting CoolFreeze CDF11
18
8 Troubleshooting
9Disposal
➤ Place the packaging material in the appropriate recycling waste bins wherever
possible.
M
If you wish to finally dispose of the product, ask your local recycling centre
or specialist dealer for details about how to do this in accordance with the
applicable disposal regulations.
Fault Possible cause Suggested remedy
Device does not function,
“POWER” LED does not
glow.
There is no voltage
present in the
12/24 V socket
(cigarette lighter) in
your vehicle.
The ignition must be switched on in
most vehicles to apply current to the
cigarette lighter.
The device does not cool
(plug is inserted, “POWER”
LED is lit).
Defective
compressor.
This can only be repaired by an
authorised customer repair agent.
The device does not cool
(plug is inserted, “POWER”
LED flashes, the display is
blank).
The voltage present
in the 12/24 V socket
is too low.
Check the battery and charge if
necessary.
Check the wiring and connections.
When operating from the
12/24 V socket (cigarette
lighter):
The ignition is on and the
device is not working and
the “POWER” LED is not lit.
Pull the plug out of the
socket and make the
following checks.
The cigarette lighter
socket is dirty. This
results in a poor
electrical contact.
If the plug of your cooler becomes
very warm in the cigarette lighter
socket, either the lighter socket must
be cleaned or the plug has not been
assembled correctly.
The fuse of the
12/24 V plug has
blown.
Replace the fuse (5 A) in the cigarette
lighter plug, see chapter “Replacing
the plug fuse (12/24 V)” on page 17.
The vehicle fuse has
blown.
Replace the vehicle’s 12/24 V socket
fuse (usually 15 A). Please refer to your
vehicle’s operating manual.
“ERROR” LED flashes and
the display shows “ERR1”
or “ERR2”.
Device is defective. This can only be repaired by an
authorised customer repair agent.
CDF11-O-16s.book Seite 18 Mittwoch, 1. März 2017 10:18 10