8. Troubleshooting
9. Important information about
electromagnetic interference
Malfunction
The device cannot be switched on.
The suction intensity is decreased.
The suction intensity is decreased.
Liquid or mucus got into the connecting
tube.
Liquid or mucus got into the connecting
tube.
Liquid or mucus got into the connecting
tube.
Reason
The device is not connected to the power
network.
The nose tip is blocked or the Colibri head
was incorrectly assembled.
The air mesh is clogged.
The Colibri head was not held in the correct
position.
The connection point of the tube is not
pointed downwards.
Too much saline solution was used.
Recommendation
Connect the power cord to the device,
then to the electric socket.
Take the Colibri head apart and clean it.
After drying the parts of the Colibri head, as-
semble them according to the User Manual.
Replace the air mesh according to the
User Manual’s “Storage and maintenance”
section.
Switch off the device and clean and dry
the Colibri head and the connecting
tube. Check the air mesh and replace it if
necessary.
Switch off the device and clean and dry
the Colibri head and the connecting
tube. Check the air mesh and replace it if
necessary.
Reduce the volume of the saline solution
to less than a teaspoon (5 ml). Switch off
the device and clean it, then dry the Co-
libri head and the connecting tube. Check
the air mesh and replace it if necessary.
Home wireless network equipment, mobile phones, and wireless
phones may affect the operation of certain medical equipment,
as electromagnetic interference can occur between devices.
Electromagnetic interference may cause harmful malfunction
in the operation of certain medical devices, potentially causing
emergency situations. It is recommended to keep at least 5 m
distance between the devices!
Due to the abovementioned reasons, medical devices must not
interfere with any other equipment. Do not use near high-perfor-
mance radiation-emitting devices.
The Nosiboo Pro2 Nasal Aspirator is intended for use in an elec-
tromagnetic environment in which radiated RF disturbances are
controlled.
The Nosiboo Pro2 nasal aspirator is certied as compliant with the
requirements of IEC 60601-1-2:2014; EN 6061-1-2:2018 (EMC test);
EN 6061-1-11:2015; EN 6061-1:2017 standards.