EN
EN - 19
We recommend an alkaline battery for longer usable life. Change the battery every 9 to
12 months for best result and avoid possible battery leakage.
• If power is temporarily interrupted the display will go blink and the radio will not play. However,
the battery back-up circuit will continue to maintain the clock and alarm settings. When power
is restored the clock will display the correct time and alarm settings, and no adjustment is
necessary.
If power is interrupted and there is no battery in the compartment or the battery is ex-
hausted. The time and alarm settings will be lost. When power is restored the clock will begin
to flash indicating that the time and alarm settings must be corrected.
1) Long press and hold the TIME/PRESET/MEM SET Button(4)
2) Press the HOUR/TUNE- SET Button (5) to advance hour press. MIN/TUNE+ SET Button (6)
until the correct time is displayed. Your Clock Radio uses a 24 hour clock.
3) Release the TIME/PRESET/MEM SET Button (4).
1) Long press and hold the AL1/VOL- SET Button(1)
2) Press the HOUR/TUNE- SET Button (5) to advance hour press. MIN/TUNE+ SET Button
(6) until the correct time is displayed Your Clock Radio uses a 24 hour clock.
3) Release the AL1/VOL- SET Button.(1).
4) To check the correct alarm time is set ,press the AL1/VOL- SET Button.(1)
AL2 with the 2.3 and the 2.4 operation
1) Set the alarm time as shown above.
2) Short press AL1/VOL- SET Button (1) to open the alarm, select a BUZZ or a radio (RA- ra-
dio /BZ-BUZZ, corresponding instructions exhibit of lanterns lit). AL2 provided with AL1.
3) Long press MIN/TUNE+ SET Button(6) fast into the number of tuning.
4) Short press MIN/TUNE+ SET BUTTON (6) step number tuning.
5) Press HOUR/TUNE- SET BUTTON (5) fast reciprocal selection such as tuning.
6) Short press HOUR/TUNE- SET BUTTON (5) step number tuning.
7) Long press TIME/PRESET/MEM SET BUTTON to enter the storage station, with the MIN/
TUNE + SET BUTTON (6) and HOUR/TUNE – SET BUTTON (5).
8) Pre existing units, according to TIME/PRESET/MEM SET BUTTON (4) can be directly to
existing radio.
1) When the alarm sounds, pressing the SNOOZE/SLEEP Button will temporary stop about 9
minutes then the alarm sounds again.
2) The standby state press the SNOOZE/SLEEP Button to turn on the radio then can choose
the radio automatic shutdown time ,followed by 120,90,60,30,15 minutes and off.
3) In the alarm sounded, press the AL key AL.OFF or corresponding can be closed when the
alarm ,If no operation ,the alarm clock rang 30 minutes will automatically stop.