5
To Use Your Frozen Dessert
Maker
Refer to Illustrations M – O
1 Switch on to MIN speed and then
use the chute to pour the mix into
the bowl.
2 After about half an hour, the ice
cream should be ready to serve.
Turn off the Stand Mixer.
3 To remove your splashguard, use
the guides at the side of the pouring
chute to push up and unclip the
front of the splashguard from the
adaptor ring.
4 Unclip the back of the splashguard.
5 If the ice cream or sorbet is not to
be used immediately, spoon the mix
into a suitable container and store in
a freezer until it is required.
Hints and Guidelines for Safe and
Succesful Operation of Frozen
Dessert Maker Attachment
O The freezing bowl should be placed
in a freezer that is operating at
-18°C or below for between 24-48
hours before use. Freezing time
will depend on efficiency of your
freezer.
O For best performance store the
bowl in either the top or bottom
drawer of your freezer in an upright
position.
O For best results chill all ingredients
for 2 hours in the refrigerator before
adding to the bowl.
O Ensure your ice cream or sorbet mix
is smooth and free of lumps before
pouring into the freezer bowl.
O Do not switch off the Stand Mixer
until the ice cream or sorbet is
ready.
O If, after 45 minutes the mix has not
reached the desired consistency,
switch the Stand Mixer off and
spoon the ice cream or sorbet into
a suitable container and place in
a freezer until it is frozen to the
required consistency.
O Do not use metal utensils to remove
mix from the freezing bowl.
O Up to 1 litre of ice cream can be
successfully produced per session.
Please note:- The length of time that
the mix takes to freeze down depends
on:
O the quantity and composition of the
mix. Addition of alcohol to the mix
will inhibit freezing.
O the original temperature of the mix.
O room temperature.
Service and Customer Care
O If you experience any problems with
the operation of your attachment,
before requesting assistance visit
www.kenwoodworld.com.
O Please note that your product
is covered by a warranty, which
complies with all legal provisions
concerning any existing warranty and
consumer rights in the country where
the product was purchased.
O If your Kenwood product malfunctions
or you find any defects, please
send it or bring it to an authorised
KENWOOD Service Centre. To find
up to date details of your nearest
authorised KENWOOD Service centre
visit www.kenwoodworld.com or the
website specific to your Country.
O Designed and engineered by Kenwood
in the UK.
O Made in China.