Introduction on Mode
Normal Mode: under this mode, the heater works at the setting level. After
reaching the setting temperature, it stops heating and the setting temperature
flashes.
Energy Saving Mode : under this mode, the heater works normally. The
level and setting temperature are not adjustable, the heater works at default
setting temperature (22 ºC). (In Energy Saving Mode, if the setting
temperature flashes, it means the heater is under energy saving heat
preservation work state). The indicator light circle indicates green.
Anti-Freezing Mode : under this mode, press the knob to adjust the level
but the setting temperature is not adjustable. The heater works at default
anti-freezing temperature (5 ºC). (In Anti-Freezing Mode, if the setting
temperature flashes, it means the heater is under anti-freezing heat
preservation work state). The indicator light circle indicates orange.
Memory Function
When the power of the heater is not cut off or the heater keeps under Standby Mode, it can
memorize the last working mode and setting temperature and works at the setting
temperature after turning on, the memory data will be reset if the power supply of the heater
is cut off, and the setting temperature of the heater recovers to the default setting (Normal
Mode, high, setting temperature is 35 ºC) when turning.
SAFETY FEATURES
Thermal cut-off: This heater includes a thermal cut-off that shuts the heater off if it
overheats due to abnormal conditions. If this occurs, turn the heater off, unplug it, and
inspect and remove any objects on or adjacent to the heater. Allow it to cool for a few
minutes, and then plug it back in and resume normal operation.
Tip-over switch: This heater includes a safety tip-over protection feature that will shut the
heater off in case it is tipped over. If, at any time, the heater tips over, please put the heater
back in the upright position. The heater will resume its normal operation.
MAINTENANCE & CLEANING
Before maintaining, please pull out the plug, and make sure the heater has become cool.
Surface cleaning: use a clean and dry wipe. If it is too dirt please wipe it with some water
under 50℃ and add little neutral detergent, then make it dry. Do not use the washing-up
liquid which is mordant, like petrol, thinner and attenuant.
TECHNICAL PARAMETERS
Power regulation range (W)