Product Safety Information
Intended Use:
These Cordless Impact Wrenches are designed to remove and install threaded fasteners.
Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, re and/or
serious injury. Save all warnings and instructions for future reference.
Responsibly recycle or dispose of Batteries. Do not puncture or burn batteries. Improper disposal may endanger the environment or cause
personal injury.
Only use Tools with appropriate voltage Ingersoll Rand batteries and Charger. Use of any other batteries may create a risk of re, personal
injury or property damage.
For additional information, refer to Cordless Impact Wrench Safety Manual Form 04581146, Battery Charger Safety Information Manual
Form 10567832 and Battery Safety Information Manual Form 10567840.
Manuals can be downloaded from ingersollrandproducts.com
Product Specications
Tool Model
Voltage
Battery
Model
Drive
Impacts per
Minute
No Load
Speed
Recommended
Torque Range
Max.
Torque
V, DC Type Size bpm rpm ft-lbs (Nm) ft-lbs (Nm)
W5111 20
BL2005
BL2012
Quick Change Hex 1/4” 2800 1900 25-120 (35-160) 160 (215)
BL2010
BL2022
Quick Change Hex 1/4” 2800 1900 25-130 (35-175) 175 (240)
W5131P 20
BL2005
BL2012
Square (Pin Retainer) 3/8” 2800 1900 25-120 (35-160) 160 (215)
BL2010
BL2022
Square (Pin Retainer) 3/8” 2800 1900 25-130 (35-175) 175 (240)
W5151P 20
BL2005
BL2012
Square (Pin Retainer) 1/2” 2800 1900 25-120 (35-160) 160 (215)
BL2010
BL2022
Square (Pin Retainer) 1/2” 2800 1900 25-130 (35-175) 175 (240)
Tool Model Battery Model
Sound level dB(A)
(EN60745)
Vibration (m/s²)
(EN60745)
† Pressure (L
p
) ‡ Power (L
w
) Level *K
W5111
BL2005, BL2012 86 97 4.7 1.2
BL2010, BL2022 86 97 6.9 1.8
W5131P
BL2005, BL2012 86 97 4.7 1.2
BL2010, BL2022 86 97 6.9 1.8
W5151P
BL2005, BL2012 86 97 4.7 1.2
BL2010, BL2022 86 97 6.9 1.8
† K
pA
= 3dB measurement uncertainty
‡ K
wA
= 3dB measurement uncertainty
* K = Vibration measurement uncertainty
Conforms to UL STD. 60745-1 & 60745-2-2.
Certied to CSA STD. C22.2 No. 60745-1 & 60745-2-2.
Lubrication
Remove hammer case to apply lubrication on the anvil, impact mechanism assembly and gears. Apply grease evenly and sparingly. An excessive
accumulation of grease will result in sluggish operation. See drawing 48380273 and table below. Maintenance frequency is shown in a circular arrow
and dened as h=hours, d=days, and m=months of actual use.
●
●
●