Whirlpool AKR 641 GY Program Chart

Kategória
Odsávače pár
Typ
Program Chart
5019 318 33068
AKR 641 - AKR 643
KARTA INSTALACYJNA
Minimalna odleg³oæ od palników: 65 cm (palniki elektryczne), 75 cm (palniki
gazowe, olejowe lub wêglowe). Podczas monta¿u nale¿y przestrzegaæ kolejnoci
numeracji (1
Ö
2
Ö
3
Ö
.....) oraz odpowiednich instrukcji. Nie pod³¹czaæ urz¹dzenia
do zasilania, zanim nie zostanie zakoñczony ca³kowicie jego monta¿. Uwaga!
Rura odprowadzaj¹ca dym i parê oraz kolanka nie s¹ dostarczane i nale¿y je
zakupiæ oddzielnie.
POPIS INSTALACE
Minimální vzdálenost od sporákù: 65 cm (elektrické sporáky), 75 cm (sporáky na
plyn, naftu nebo uhlí). Pøi montái sledujte èíslování (1
Ö
2
Ö
3
Ö
.....) a pøísluné
pokyny. Spotøebiè pøipojte k elektrické síti a po úplném dokonèení instalace.
Upozornìní! Nasávací trubka a pásky k upevnìní nejsou souèástí vybavení,
musíte je zakoupit.
INTALAÈNÁ SCHÉMA
Minimálna vzdialenost' od sporáka: 65 cm (elektrické sporáky), 75 cm (plynové
sporáky, sporáky na naftu alebo uhlie). Pri montái postupujte pod¾a èíslic
(1
Ö
2
Ö
3
Ö
.....) a dodrujte prísluné pokyny. Spotrebiè nezapájajte do siete, kým
nie je intalácia úplne ukonèená. Upozornenie! Rúra na odvádzanie dymov a
upevòovacie svorky sa nedodávajú, musíte ich kúpit' samostatne.
ÜZEMBE HELYEZÉSI ÚTMUTATÓ
A tûzhelytõl való minimális távolság: 65 cm (elektromos tûzhely), 75 cm (gáz-,
olaj- vagy széntüzelésû tûzhely). A felszereléshez kövesse a számozást
(1
Ö
2
Ö
3
Ö
.....) és a vonatkozó utasításokat. A készüléket csak akkor szabad áram
alá helyezni, ha a beüzemelés már megtörtént. Figyelem! Az elvezetõ csõ és a
rögzítõpántok nem tartozékok, így azokat külön meg kell vásárolni.
PL
CZ
SK
H
31833068.fm Page 1 Monday, December 23, 2002 10:00 AM
5019 318 33068
AKR 641 - AKR 643
ÈÍÑÒÐÓÊÖÈÈ ÏÎ ÓÑÒÀÍÎÂÊÅ
Ìèíèìàëüíîå ðàññòîÿíèå äî êîíôîðîê: 65 ñì (ýëåêòðè÷åñêèå
êîíôîðêè), 75 ñì (ãàçîâûå, êåðîñèíîâûå èëè óãîëüíûå). Ïðè ìîíòàæå
âûïîëíÿéòå äåéñòâèÿ â ñîîòâåòñòâèè ñ íóìåðàöèåé (1
Ö
2
Ö
3
Ö
.....) è
èíñòðóêöèÿìè. Íå ïîäêëþ÷àéòå ïðèáîð ê ýëåêòðè÷åñêîé ñåòè äî
îêîí÷àíèÿ óñòàíîâêè. Ïðåäóïðåæäåíèå! Âûòÿæíàÿ òðóáà è êðåïëåíèÿ íå
âõîäÿò â êîìïëåêò ïîñòàâêè è ïðèîáðåòàþòñÿ îòäåëüíî.
ÊÀÐÒÀ ÇÀ ÈÍÑÒÀËÈÐÀÍÅ
Ìèíèìàëíî ðàçñòîÿíèå îò ïå÷êè: 65 ñì (åëåêòðè÷åñêè ïå÷êè), 75 ñì
(ïå÷êè ñ ãàç, íàôòà èëè âúãëèùà). Çà ìîíòàæ ñëåäâàéòå íîìåðàöèÿòà
(1
Ö
2
Ö
3
Ö
.....) è ñúîòâåòíèòå èíñòðóêöèè. Íå âêëþ÷âàéòå çàõðàíâàíåòî
íà óðåäà, äîêàòî èíñòàëèðàíåòî íå å çàâúðøåíî äîêðàé. Âíèìàíèå!
Òðúáàòà çà îòâåæäàíå íå å ïðåäîñòàâåíà è òðÿáâà äà ñå çàêóïè
îòäåëíî.
FIªA DE INSTALARE
Distanþa minimã de la arzãtoare: 65 cm (arzãtoare electrice), 75 cm (arzãtoare pe
bazã de gaze, motorinã sau cãrbune). Pentru montare urmaþi numerotarea
(1
Ö
2
Ö
3
Ö
.....) ºi instrucþiunile corespunzãtoare. Nu branºaþi aparatul la curent
pânã când nu terminaþi definitiv operaþia de instalare. Atenþie! Tubul de evacuare
ºi manºoanele de fixare nu fac parte din dotare ºi trebuie sã fie cumpãrate
separat.
INSTALLATION SHEET
Minimum height above cooker: 65 cm (electric cookers), 75 cm (gas, gas oil or
coal cookers). To assemble follow the numbers (1
Ö
2
Ö
3
Ö
.....) and relative
instructions. Do not connect the appliance to the electrical power supply until
installation is completed. Warning! The exhaust pipe and clamps are not
supplied and must be bought separately.
RUS
BG
RO
GB
31833068.fm Page 2 Monday, December 23, 2002 10:00 AM
5019 318 33068
AKR 641 - AKR 643
31833068.fm Page 3 Monday, December 23, 2002 10:00 AM
5019 318 33068
AKR 641 - AKR 643
31833068.fm Page 4 Monday, December 23, 2002 10:00 AM
5019 318 33068
AKR 641 - AKR 643
Preliminary information for installing the hood:
Disconnect the power supply at the domestic main switch before carrying out electrical connections.
1. Fix 2 support brackets D (Fig. 1) to the sides of the wall unit (one each side) using 2 screws per bracket
(the brackets must be parallel with the lower edge of the unit).
Position the support bracket so that it is against the back of the wall unit, making sure that the rear edge
of the bracket matches the back of the hood.
Drill an opening at the top of the wall unit for the exhaust pipe and the power supply cable.
2. Fix 2 support brackets E (Fig. 2) to the sides of the hood (one each side).
a. Pull out the deflector;
b. remove the grease filter/s;
c. from the inside of the hood, secure the support brackets using two screws P per bracket, making
sure to place the brackets as high as possible (near the outlet duct), then tighten the screws.
3. Fit the hood inside the wall unit, being careful to position the hood bracket E above the wall unit bracket
D (Fig. 1-2).
Insert the power supply cable through the opening made for the purpose.
4. Secure the hood with two screws in front (Fig. 3 - one each side).
5. Carry out the electrical connection to the mains power supply, only turn on the power supply with
assembly completed.
6. If necessary, adjust the alignment by loosening the screws P of the brackets E mounted on the hood
(Fig. 2) until the hood and the lower edge of the wall unit line up perfectly, then tighten the screws again.
7. Adjust the deflector slideout stroke according to the depth of the wall unit by adjusting the two retainers
F (Fig. 5). In this way the front will be perfectly aligned with the wall unit.
a. Loosen the screws of the retainers F;
b. Adjust by moving the retainers backwards or forwards;
c. tighten the screws of the retainers.
8. Fix an outlet duct to the collar C supplied. The outlet duct diameter should be the same as that of the
collar (Fig. 4). The exhaust pipe must be long enough to vent externally (extractor version) or must reach
the top of the wall unit (filter version).
9. Fix the collar C (snap-close) to the top section of the hood discharge.
To facilitate installation, the collar has a mark G that must match the specific guide H on the exhaust
duct.
10. Complete the installation of the exhaust duct.
Refit the grease filter/s, connect the hood to the power supply and check for correct hood operation.
INSTALLATION - ASSEMBLY INSTRUCTIONS
PL SK H RUS
CZ
BG RO GB
31833068.fm Page 19 Monday, December 23, 2002 10:00 AM
5019 318 33068
AKR 641 - AKR 643
1. Control panel.
2. Grease filter
(1 or 2 pieces depending on model).
3. Grease filter spring release handles.
4. Lighting unit.
5. Pull-out steam deflector.
6. Extractor unit body.
Removing and/or washing the grease
filter/s
1. Disconnect the electrical power supply.
2. Remove the dirty grease filter/s by pulling the
handle first backwards and then downwards
(Fig. 1).
3. After cleaning the grease filter refit in reverse
order, making sure the entire extraction surface
is covered.
Replacing bulbs
1. Disconnect the electrical power supply.
2. Use a small screwdriver or any other suitable tool
to prise off the lamp cover (Fig. 2).
3. Remove the burnt-out bulb.
4. Replace using 40 W max E14 bulbs only.
5. Replace the lamp cover so that it clicks into
position.
Fitting or renewing the carbon filter:
1. Disconnect the electrical power supply.
2. Remove the grease filter/s (Fig. 1).
3. If the carbon filters are already mounted (one or
two filters, depending on the model, covering the
motor protection grille) and need renewing, turn
the central handle (Fig. 3 - c) anticlockwise until
the filters release.
4. If the carbon filters are not already mounted,
locate the filters to cover the motor protection
grilles (two protection grilles - two carbon filters,
one protection grille - one carbon filter), then
turn the central handle (Fig. 3 - c) of the filters
clockwise.
5. Refit the grease filter/s (Fig. 1).
CONTROL PANEL
Light switch.
The switch has two positions
(lights OFF - lights ON).
To switch on the lights: move the switch to the
right.
Motor switch.
The extraction speed switch has 3 settings,
depending on the amount of steam and fumes.
To increase the extraction speed: move the
switch to the right.
Fig. 1
Fig. 2
Fig. 3
PRODUCT SHEET
PL SK H RUS
CZ
BG RO GB
31833068.fm Page 20 Monday, December 23, 2002 10:00 AM
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Whirlpool AKR 641 GY Program Chart

Kategória
Odsávače pár
Typ
Program Chart

v iných jazykoch