Haier HDSV985B Decorative Hood Používateľská príručka

ITALIANO

FRANÇAIS NOTICE D'INSTALLATION ET D' UTILISATION

ESPAÑOL MANUAL DE USO E INSTALACIÓN

SLOVENČINA NÁVOD NA INŠTALÁCIU A POUŽITIE

MANUALE D'INSTALLAZIONE E D'USO

INSTALLATION AND USER’S MANUAL

ENGLISH

NÁVOD K INSTALACI A POUŽITÍ

ČEŠTINA

INSTALLATION AND USER’S MANUAL

CONTENT

INTRODUCTION

03

SAFETY PRECAUTION

03

ELECTRICAL INSTALLATION

05

SPECIFICATION

06

INSTALLATION (VENT OUTSIDE)

07

INSTALLATION (VENT INSIDE)

16

DESCRIPTION OF COMPONENTS

17

OPERATION

17

MAINTENANCE

20

TROBULESHOOTING

21

CONFORMITY WITH DIRECTIVES

22

ENVIRONMENTAL PROTECTION

22

2

INTRODUCTION

Thank you for choosing this cooker hood.

This instruction manual is designed to provide you with all required

instructions related to the installation, use and maintenance of the appliance.

In order to operate the unit correctly and safety, please read this instruction

manual carefully before installation and usage.

The cooker hood uses high quality materials, and is made with a streamlined

design. Equipped with large power electric motor and centrifugal fan, it also

provides strong suction power, low noise operation, non-stick grease filter and

easy assembly installation.

Hereby, Candy Hoover Group Srl declares that the radio equipment is in

compliance with Directive 2014/53/EU and with the relevant Statutory

Requirements (for the UKCA market).

internet address: www.candy-group.com

SAFETY PRECAUTION

� Never let the children operate the machine.

� The cooker hood is for home use only, not suitable for barbecue, roast

shop and other commercial purpose.

� The cooker hood and its filter should be clean regularly in order to keep in

good working condition.

� Clean the cooker hood according to the instruction manual and keep the

unit from danger of burning.

� Forbid the direct baking from the gas cooker. Please keep the kitchen

room a good convection.

� Before connecting this appliance check that the power supply cord is not

damaged. A damage supply cord must be replaced by qualified service

personnel only.

� There shall be adequate ventilation of the room when the range hood is

used at the same time as appliances burning gas or other fuels;

� The air must not be discharged into a flue that is used for exhausting

fumes from appliances burning gas or other fuels;

� Regulations concerning the discharge of air have to be fulfilled.

3

The full text of the declaration of conformity is available at the following

Electrical Shock Hazard

Only plug this unit into a properly earthed outlet. If in doubt seek advice

from a suitably qualified engineer.

Failure to follow these instructions can result in death, fire, or electrical

shock.

5IFTFTIBMMCFBEFRVBUFWFOUJMBUJPOPGUIFSPPNXIFOUIFSBOHF

IPPEJTVTFEBUUIFTBNF UJNFBTBQQMJBODFTCVSOJOHHBTPSPUIFS

GVFMTOPUBQQMJDBCMFUPBQQMJBODFTUIBUPOMZEJTDIBSHFUIFBJSCBDL

JOUPUIFSPPN

UIFEFUBJMTDPODFSOJOHUIFNFUIPEBOEGSFRVFODZPGDMFBOJOH

UIFSFJTBGJSFSJTLJGDMFBOJOHJTOPUDBSSJFEPVUJOBDDPSEBODFXJUIUIF

JOTUSVDUJPOT

EPOPUGMBNFVOEFSUIFSBOHFIPPE

$"65*0/"DDFTTJCMFQBSUTNBZCFDPNFIPUXIFOVTFEXJUI

DPPLJOHBQQMJBODFT

�

- Children should be supervised to ensure that they do not play with

the appliance.

- Do not flambé under the range hood.

- he range hood is not intended to be installed over a hob having more

than four hob elements

4

Electrical Installation

All installation must be carried out by a competent person or qualified

electrician. Before connecting the mains supply ensure that the mains

voltage corresponds to the voltage on the rating plate.

Direct Connection

The appliance must be connected directly to the mains using an omnipolar

circuit breaker with a minimum opening of 3mm between the contacts.

The installer must ensure that the correct electrical connection has been

made and that it complies with the wiring diagram.

The cable must not be bent or compressed.

Regularly check the power plug and power cord for damage. If the supply

cord is damaged, it must be replaced by a special cord or assembly

available from the manufacturer or its service agent.

WARNING: This is a Class I appliance and MUST be earthed This

appliance is supplied with a 3 core mains cable coloured as follows:

Brown = L or Live

Blue = N or Neutral

Green and Yellow = E or Earth

The fuse must be rated at 3 Amps.

5

Standard Installation Accessories List

Spec.

Illustration Picture

Qty

Hood body 1

Lower chimney

(500mm) 1

Upper chimney

(500mm) 1

Upper chimney

bracket 1

Lower chimney

bracket 1

Cooker hood bracket 1

φ8 rawl plugs φ8×φ6

white color 9

Screw (ST4 * 8 mm)

9

Screw (ST4 * 30 mm)

6

Air outlet 1

Carbon ﬁlter 2

6

INSTALLATION (wall mounting)

If you have an outlet to the outside, your cooker hood can be connected as

below picture by means of an extraction duct (enamel, aluminum, flexible pipe

non flammabe with an interior diameter of 150mm)

1. Before installation, turn the unit off and unplug it from the outlet.

2. The cooker hood should be placed at a distance of 65~75cm above

the cooking plane for best effect.

7

INSTALLING THE HOOD

Position the hood at the desired height respecting the minimum height

above the hob.

Mark the location of the wall bracket.(Placed the holes between 700 and

800 mm above the worktop) Remove the hood and position the wall bracket

to mark the locations of the holes on the wall.

Drill the 3 holes in the wall to insert the appropriate fastening system (screw

ST4x30mm)..

Hang the hood in the notches of the wall

bracket.

8

INSTALLING THE HOOD

Once the hood is in place, locate the location of the 4 additional wall mount

screws as shown in the following diagram.

Remove the hood to puncture the wall and install wall plugs.

Secure the body of the hood with 4 screws of 4 mm in diameter using

dowels adapted to your wall.

If the extraction mode is selected, place the

exhaust air duct on the air outlet as shown.

9

INSTALLING THE HOOD

Attach the lower chimney support to the lower chimney as shown.

Use 2 screws ST4x8mm.

(Do not over tighten the screws, make sure the upper chimney can slide

easily into the lower chimney)

Insert the upper chimney into the lower chimney.

Position the bottom chimney in the appliance, then mark the holes on the

wall.

Remove the lower chimney, then drill holes in the wall: hole for screw

diameter Φ8 mm

Use the dowels adapted to your wall

10

INSTALLING THE HOOD

Install the lower chimney, then screw it to

the wall with 2 screws of diameter Φ 8 mm

Then pull the upper chimney upwards

to the desired height. Mark the

locations of the mounting holes of the

upper chimney support.

Lower the upper chimney and then drill

holes in the wall.

Insert the dowels adapted to your wall

11

INSTALLING THE HOOD

Secure the wall bracket of the upper

chimney to the wall using the selected

dowels (8 mm screws recommended).

Reassemble the upper

chimney and fix it to the wall

bracket with 2 screws

ST4x8mm

Fasten the lower chimney to the lugs of the

kitchen hood using 2 screws ST4x8mm.

12

Standard Installation Accessories List

Spec. Illustration Picture Qty

Air Deflector

1

Bracket

1

φ8 rawl plugs

φ8×φ6 white color 2

Screws

ST4.0×30

2

Screws

ST3.5×12

2

13

INSTALLATION(AIR DEFLECTOR FOR T-SHAPE,CURVED

GLASS,FLAT GLASS MODELS):

Air deflector is mentioned as included and not optional.

1. Fix the bracket to the T-shaped plastic outlet with 2pcs ST3.5x12mm

screws provided as shown below:

2. Drill 2 holes on the wall to accommodate the wall plugs,then screw and

tighten the bracket onto the wall with 2pcs ST4x30mm screws provided.

3. Attach the exhaust pipe onto the air outlet of the cooker hood as shown

below:

14

4. Install the chimney to the unit and fix it.

o“Please kindly be noted: T-shaped plastic outlet and v-flaps can not

be use d at the same time. You can use them in two ways: 1) Add v-

flap on existing o utlet; 2) Use T-shaped plastic outlet, no add v-flap.”

o“Note: The product is provided with v-flap accessory. This accessory

is not mandatory for installation, operation and use of the product.”

15

INSTALLATION (VENT INSIDE)

If you do not have an outlet to the outside, exhaust pipe is not required and

the installation is similar to the one show in section “INSTALLATION (VENT

OUTSIDE)”.

Activated carbon filter can be used to trap odors.

In order to install the activated carbon filter, the grease filter should be

detached first. Press the lock and pull it downward.

Plug the activated carbon filter into the unit and turn it in clockwise direction.

Repeat the same on the other side.

NOTE:

oMake sure the filter is securely locked. Otherwise, it would loosen and

cause dangerous.

oWhen activated carbon filter attached, the suction power will be

lowere

16

Wi-Fi Connection

Long press WiFi icon and enter into connecting mode: the backlit of WiFi icon

keep flashing indicate the connection is under connecting, the backlit of WiFi

icon is light on indicate it is connected, same for standby mode; long press

WiFi icon again and the connection will be stopped;

DESCRIPTION OF COMPONENTS

OPERATION

Boost 1(speed 4)

Press speed b button 1 , the backlit of speed B button is on, and the cooker

hood is working at boost mode ;

Boost 2(speed 5)

Press speed b button 2 , the backlit of speed B+ button is on, and the

cooker hood is working at boost mode ;

Light

Short press for lighting on & off

Quick timer: Long press the light button hold for 3 seconds, fan speed

buttons will flashing & into 5minutes count down, aft er 5 minutes motor &

light will turn off automatic with three Buzzer sound.

Medium Speed button

Airflow speed is ideally for ventilation in standard cooking operation.

High Speed button

When high density of smoke or steam produced, press high-speed button

for high effective ventilation.

CONFIGURATION 1

Low Speed button

It’s used for Ventilation on the kitchen. It is suitable for simmering and

cooking which do not make much steam.

17

STANDBY MODE.

After plug in, all lighting, system in

STANDBY MODE

.

Medium Speed button

Airflow speed is ideally for ventilation in standard cooking operation.

High Speed button

When high density of smoke or steam produced, press high-speed button

for high effective ventilation.

Booster function

This hood has a booster function. To activate the booster, Press

to speed 4, enter into highest speed while the hood is in use and it will

increase speed for 5 minutes, before slowing down again.

Light

Short press for lighting on & off

Quick timer: Long press the light button hold for 3 seconds, fan speed

buttons will flashing & into 5minutes count down, after 5 minutes motor &

light will turn off automatic with three Buzzer sound.

CONFIGURATION 2

Wi-Fi Connection

Long press WiFi icon and enter into connecting mode: the backlit of WiFi

icon keep flashing indicate the connection is under connecting,

the

backlit of WiFi icon is light on indicate it is connected, same for standby

mode; long press WiFi icon again and the connection will be stopped;

Low Speed button

It’s used for Ventilation on the kitchen. It is suitable for simmering and

cooking which do not make much steam.

18

Download hOn App

First of all, you should download hOn APP and install to your portable device. Then

enroll your hood.

NOTE

ENROLLMENT HAIER HOOD

1- Press the WiFi button until the icon starts blinking When the pairing is

completed the WiFi icon will be on.

19

The image of the hood has the only purpose of presenting it. May not be perfectly representative.

Stránka sa načítava...

Haier HDSV985B Decorative Hood Používateľská príručka

Haier HDSV985B Decorative Hood Používateľská príručka

v iných jazykoch

Súvisiace články

Ostatné dokumenty