EN
EN - 6
4. Wait until the LCD display shows all the information.
5. Place the object to be weighed on the scale (or in the bowl) and the LCD display
will show the determined weight of the object.
Switching modes using the UNIT button
1. Place the container on the weighing area.
2. Press the ZERO/1 button to reset the weight of the container, the display will show
„0“.
3. Press the UNIT button switch between the individual measuring modes. Following
modes are available:
for weight measuring (units are g)
for water volume measurement (units are ml)
for milk volume measurement (units are ml)
Topping up weight and tare function
These functions are used to measure the weight of the additional batches gradually
added to the previous ones, which remain on the scale. Place the rst batch on the
scale and the weight will appear on the display. Before adding of another batch on the
scale, touch the button ZERO/1, the value on the display will reset (to „0“). You can
perform this operation repeatedly.
• Each time you press ZERO/1 the LCD display will show „ ----- “ or „0g“. „ ----- “
means unstable, please, wait a moment. While the „0g“ is displayed an icon „O“ or
„T“ lights up in the left bottom corner (depending on the weight), indicating that
the topping up function is active. Max. capacity does not change.
• If the total sum of the weights of all batches on the scale is less than 200 g, the
topping up function will be used automatically. The scale resets after each pressing
of the button.
• If the total sum of the weights of all batches on the scale is higher than 200 g, the
TARE function will be used automatically. The rst time you press the button in
this mode, you will see the total weight / volume of all items. Only after the second
press will the scale reset, after which you can continue weighing.
Switching weighing units
You can switch between measuring units (metric, i.e. g/ml and imperial i.e. lb:oz, ’oz)
by pressing and holding the UNIT button. When the scale is on, press and hold the
button. The LCD display shows the units which you just used.
Turning off the scale
You can turn off the scale using either the button ZERO/1 or the scale turns off auto-
matically after 2 minutes.
Error messages on the display
Overload. If you load the scale more than
the permissible limit, this error message
will appear on the display. Reduce the
load to prevent damage to the scale.
Low battery warning. Charge the bat-
tery according to the instructions above.