The appliance is intended for processing almost all kinds of fruit and vegetables.
Currant, bananas, avocado, figs, mango etc. are not suitable for processing in the juicer.
Always use fresh, ripe fruits and vegetables which will give you more juice.
Remove the stems and haulms.
Wash the fruit or vegetables thoroughly.
Cut bigger foods into smaller pieces.
Remove pits (e.g. with plums, apricots, cherries, etc.)
Remove thick skin (e.g. with melons, pineapples, cucumbers, potatoes, beet, celery, etc.)
Peel citrus fruits and remove white pulp and seeds; otherwise the juice could turn bitter.
Foods with thin skin do not need to be peeled (e.g. apples, pears, carrots, radish, parsley,
etc.).
Place the assembled juicer on a firm, flat and dry surface (see par.
). Plug the fork of the supply cord A4 into the el. outlet. Place the container
G without the lid G1 or another suitable container for juice. Turn the appliance on by
turning the speed-selector A1 to desired position according to the food processed.
– When processing soft/juicy food (e.g. , etc.), turn the
selector to position 1 (low speed).
– When processing food with lower juice ration (e.g. , etc.), choose
a higher speed.
– When processing hard food (e.g. ), turn the regulator to position 5 (high speed).
Feed the prepared food into the feeding opening D1 a push them slightly with the stamper
E. Do not push hard on the stamper, it could affect quality of the juice or even cause the
appliance to stop. Having finished using the appliance, turn it off, wait till the rotating sieve
stops completely and unplug the appliance from the outlet by pulling out the fork of the
supply cord from the socket. Before pouring the juice, put the lid G1 on the container G
which will catch the foam.
– We recommend suspending work once in a while and removing the pulp which has
collected on the sieve or the lid (see par. ).
– The preparation times depend on amount, kind and quality of the food used and range
in tens of seconds. Maximum time of continuous operation is 2 minutes, then leave the
appliance rest and cool down for approx. 2 min.
– If you need to empty the pulp container F during the process, turn off the appliance first.
Lift the container, tilt it and remove it. Replace it reversely after emptying.
– The appliance features a feedback regulation which maintains the set motor revolutions
independently of the load. In case of relieving it after a big load, the revolutions may
fluctuate shortly. This is absolutely normal and is not a reason to take the device back.
– If the appliance becomes stuck, turn it off immediately and clean it.
– To get more juice, push soft foods slowly.
– To keep as many vitamins as possible, consume the juice soon.
– In case you need to keep the juice for several hours, put it in a refrigerator. The juice will
stay fresh longer if you add a few drops of lemon juice.
– Water down the juice for children with same amount of water.
GB