EN - 6
02/2012
Copyright © 2012, Fast ČR, a. s.
• If possible, place the appliance into a cool, well ventilated and dry room.
• Do not locate the appliance in direct sunlight, or in a room with a high temperature, in the vicinity of any
sources of direct heat, such as heating, an oven, a stove, etc. - this would mean that the fan would need to
work a lot harder resulting in a substantially higher power consumption level.
If it is not possible to prevent the installation in the vicinity of a heat source, we recommend the insertion of an
appropriate insulating board (do not use asbestos) between the appliance and the heat source; or at least to
maintain the following minimum distances:
• From a gas or electric stove 3 cm;
• From a heater or oven, etc. 30 cm;
• From another cooling appliance 2 cm.
Do not place any appliances on the appliance, which release heat on to the appliance, such as microwave
ovens, toasters, etc.
Never cover the ventilation grill. Pull out the power plug by pulling on the plug itself, never pull on the cord
when disconnecting the appliance.
Before turning on the appliance allow it to stand in its nal location for 12 hours, the coolant circuit
will stabilise in this way and no operating problems will occur. Before connecting the appliance to
the power grid check that it is perfectly dry inside – especially in the corners.
Cleaning before use
Check that you have removed from the appliance all adhesive tape used to hold accessories . Then clean all the
inside parts using lukewarm water with a neutral cleaning agent, vinegar or sodium carbonate – in this way
you will remove the characteristic odour of new parts – then dry carefully. Do not use detergents or aggressive
agents, which could damage the surfaces.
Electrical connection
Before connecting the power plug to the power socket, check that:
• Your hands are completely dry.
• The voltage and frequency shown on the performance label of the appliance corresponds to that in
the home power grid (permitted tolerance from -6% to +6% for nominal voltage, for use with di erent
voltages, use a voltage changer with the corresponding parameters).
• The cord and the plug are not damaged or caught under heavy objects.
• The power cord is not excessively tensioned, it is not permitted to use an extension cord.
Do not connect the appliance to a voltage recti er (e.g. solar power plant) or use an extension cord.
The appliance must be connected to a working grounding lead.
If the power socket of the home system is not grounded in accordance with the current legal
regulations, connect the appliance after consulting a specialised technician to the grounding lead
itself.
The manufacturer takes no responsibility for injuries caused as a result of not following these
instructions.