Gas Stove TRAVELER DUO e
-3-
Disconnecting or replacing the cartridge
źClose the valve using the controller and allow device to cool
down.
źThe cartridge is released using the lever, next to the controller,
in the UNLOCK position.
źRemove the cartridge and, if necessary, replace it with a new
one according to the instructions (Connecting the gas car-
tridge).
źThe gas cartridge can only be replaced outdoors, away from
any source of ignition and out of reach of others.
Cooking and heating food
źDevice must be placed on a level surface.
źA pan/pot with a maximum diameter of 20 cm can be placed
on the stove. The use of larger pots is not allowed - risk of gas
cartridge overheating.
źStove should always remain clean, dont overfill the pot!
(risk of extinguishing the fire and clogging the burner)
Maintenance
Always perform maintenance on device at regular intervals and
in cases of heavy dirt build-up. Allow device to cool down. After
disconnecting the cartridge, make sure that the valve is not dirty
and check the seals. It is also advisable to check the valve regu-
larly and protect it from dirt. The piezo ignition coil can be clea-
ned with a metal brush. Casing and the cover of the cartridge
compartment can be washed with a damp cloth. Always allow
the appliance to dry thoroughly after washing.
Defects and their elimination
Fault: The gas cartridge cannot be connected
źIf the cartridge is too hot, it will not be able to connect to the
device due to high pressure, cool it, and then try connecting
again.
źCheck and, if necessary, clean the valve with dry cloth.
Fault: The burner cannot be ignited.
źCheck the filling level of the cartridge (after removal, there is
no movement of the contents of the cartridge when shaken).
Please note that as the cartridge temperature decreases and
the amount of gas decreases, so does the pressure, and the
performance of the device decreases proportionally.
źIf the burner nozzles are clogged (and cannot be cleaned) or
there is a fault in the valve (ignition), contact a specialist
workshop.
źIf the piezo lighter electrode is clogged or wet, clean it and
allow it to dry.
źIf the piezo lighter electrode is bent, bend it back to the burner.
Storing
źThe appliance and the gas cartridge must be stored separate-
ly.
źStore the appliance in closed, well-ventilated areas free of
aggressive substances, at a temperature of up to 10°C and a
relative humidity of up to 80%.
źStore the cartridge in a cool, dry place.
Disposal
If you decide to dispose of your old appliance, put it in the desig-
nated place (Collection yard).
Do not open the cartridge by force, never throw it into a fire.
Safety requirements
źThe device may only be operated by an adult over the age of
18 in accordance with these instructions! During operation,
the operator must also observe the general fire safety regu-
lations!
źThe device must be stored out of the reach of children!
źDo not use the device if it is leaking, damaged, or if it works
incorrectly!
źTo check for leaks in your appliance, do so outdoors. Do not
detect leaks by open fire, use soapy water!
źAccessible parts of the device near the burner are very hot
during and immediately after operation!
źKeep small children out of vicinity of the appliance!
źDevice must be placed on a non-flammable surface and have
to be supervised during operation!
źFrom the point of view of fire safety, device must be placed at
least 50 cm from flammable materials!
źCheck for leaks in a well-ventilated room or outdoors, away
from sources of ignition and out of reach of other people!
źProtect the gas cartridge from sunlight!
źIt is forbidden to use the appliance in rooms and areas below
ground level!
źFor safety reasons, do not modify parts of device!
źDo not use device in strong wind!
źDo not move device while it is in operation!
źDo not connect a gas source, other than what is specified in
the manual!
źDo not use the appliance in an environment where you work
with ethers, paints, adhesives, etc.!
WARNING
Device consumes oxygen during operation and in an unventila-
ted room (caravan, tent, cottage, boat, etc.), the user can be seri-
ously endangered due to lack of oxygen and increased CO2 con-
centration! It is always necessary to ventilate. It is necessary to
ensure a sufficient supply of combustion air and at the same time
it is necessary to prevent any dangerous accumulation of unbur-
ned fuel at the stove! Butane is physically heavier than air and, in
the event of a leak, it sinks and accumulates on the ground due
to its heavy nature.
Note
We reserve the right to make changes to the technical data. The
images are non-binding due to the constant innovation process.
Printing errors reserved.