Dear customer,
thank you for choosing the EVOLVEO Lumos LED lamp of NG series.
1. Remove the lamp from the shipping box and place it on a table or other stable
surface.
2. Connect the power adapter cable to the input on the back of the lamp.
3. Connect the supplied power adapter to the 230 V socket.
4. To turn the lamp on, touch the switch lightly, each touch increases the lamp's
brightness by one level until it is completely switched off (circular cycle).
5. To adjust the angle of the arm, hold the base and simply swing the flexible arm to the
desired position.
Caution: The LED lamp may become hot during operation, so let the lamp and the power
supply cool down before handling it again.
TROUBLESHOOTING
Contact the EVOLVEO technical support: www.evolveo.com/en/support
The warranty DOES NOT APPLY to:
using the device for other purposes than it was designed to
electrical and mechanical damage caused by improper use
damage caused by natural elements such as fire, water, static electricity, power surges
etcetera
damage caused by an unauthorized repair
wear and tear caused by normal use of the product
unreadable serial number
Disposal
The symbol of crossed out wheelie bin on the product, within the literature or on the
packaging reminds you that in the European Union, all electric and electronic products,
batteries and accumulators must be stored as assorted waste after the end of their
service life. Do not throw these products into the unsorted municipal waste.
DECLARATION OF CONFORMITY
Hereby, the company Abacus Electric, s.r.o. declares that EVOLVEO Lumos GA is in
compliance with the requirements of the standards and regulations, relevant for the given
type of device.
Find the complete text of Declaration of Conformity at ftp://ftp.evolveo.com/ce
Copyright © Abacus Electric, s.r.o.
www.evolveo.com
www.facebook.com/EvolveoEU
All rights reserved.
Design and specification may be changed without prior notice.