www.scarlett-europe.com SC-1011
3
GB INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
· Before the first connecting of the appliance check that voltage indicated on the rating label
corresponds to the mains voltage in your home.
· For home use only. Do not use for industrial purposes. Do not use the appliance for any
other purposes than described in this instruction manual.
· Do not use outdoors.
· Do not disassemble the juice extractor when it is plugged to the power supply. Always unplug the appliance from
the power supply before cleaning and when not in use.
· To prevent risk of electric shock and fire, do not immerse the appliance in water or in any other liquids. If it was
happened, unplug it immediately and check in service center.
· Close supervision is necessary when it is used near children.
· Do not leave the appliance switched on when not in use.
· Do not use other attachments than those supplied.
· Do not operate after malfunction or cord damage.
· Do not attempt to repair, adjust or replace parts in the appliance. Check and repair the malfunctioning appliance in
the nearest service center only.
· Keep the cord away from sharp edges and hot surfaces.
· Do not pull, twist, or wrap the power cord around appliance.
· Do not place the appliance near gas or electric oven or store at heated surface.
· Avoid contacting with moving parts.
· Do not run juice extractor continuously for longer than 5 minutes. Turn off switch and let it rest for at least 2
minutes to cool down the motor, otherwise the motor may be damaged.
· Every time make sure that appliance unplugged and all moving parts with motor are stopped completely before
disassembling and cleaning.
· Be sure to switch off the unit after each use.
BEFORE USING FOR THE FIRST TIME
· After unpacking the unit and before any use, make sure the mechanical parts of the unit and all attachments are
not damaged.
· Wash and dry all parts of the appliance, which will come into contact with products. To clean the outside of the
body use a damp sponge.
HOW TO ASSEMBLE
· Make sure the unit is switched off and unplugged.
· Put the jug on the motor unit and turn it clockwise to lock in place.
· Place separator in the jug turning it left and right to fit in proper position.
· Set the cone (3) onto the motor shaft, designed for small citrus (lemon, lime).
· In case of need set the cone (4) onto the cone (3) designed for larger citrus (orange, grapefruit).
· Cut the fruit in half.
· Using the built-in adjustable pulp control choose the required size of the filter holes.
· Press gently each half to a cone.
· Citrus juicer will start automatically/
· When process is completed, switch off and unplug the unit.
CLEANING
· Remove and wash all removable parts in warm soapy water. Rinse filter assembly from under side for easy
removal of residue from strainer holes. Do not use a dishwasher or very hot water.
· Do not use steel woods, abrasive cleaners or scouring pad on appliance.
· To clean the outside of the motor unit, use a damp sponge.
· Never immerse lower body in water.
Storage
· Store assembled cleaned and dried juice extractor in a dry place.
· The cord could be winded into a cord storage compartment provided in the base unit.
RUS
· , ,
, .
· .
.
· .
· , .
, .
· ,
. ,
.
· .
· .
· , .
· .