Note: We advise you to place the tip facing the front of the handle
as the illustration shows, but the nozzle can be placed in the
handle either way without affecting the function. You can try both
options and use what works best for you in your oral care routine.
Note: Replace the nozzle (HX8032, HX8033) every 6 months for
optimal results. Also replace the nozzle if it becomes loose or no
longer ‘clicks’ onto the handle.
Note: The AirFloss Ultra only supports AirFloss Ultra nozzles. Do
not attempt to use non-AirFloss Ultra nozzles on the AirFloss Ultra
handle.
2 Open the cover of the reservoir (‘click’) (Fig. 5).
3 Fill the reservoir with mouthwash or water. (Fig. 6)
Tip: For the best result and a fresher experience, we advise you to
use mouthwash with your AirFloss Ultra.
Note: Do not use mouthwash that contains isopropyl myristate
(e.g. Dentyl Active) or high concentrations of essential oils, as it
may damage the appliance. This includes all mouthwash sold in
glass and ceramic packaging.
4 Close the cover of the reservoir by pressing (‘click’) (Fig. 7).
5 Press the power/mode button to switch on the appliance. (Fig. 8)
The LEDs illuminate.
6 Press and hold the activation button until spray comes out of the
tip of the nozzle. (Fig. 9)
Using the appliance
1 Make sure the AirFloss Ultra is switched on. If it is off, press and
release the power/mode button to switch on the appliance. (Fig. 8)
You can change the modes to have the desired amounts of bursts
each time you press the activation button (Fig. 9). For optimal
results, use the triple burst mode (the default setting) from both
the outside and inside of your teeth.
To change modes, press the power/mode button to cycle through
the modes until you reach your desired mode. The LEDs show the
selected mode:
- Single burst: 1 LED (Fig. 10)
11
English