Whirlpool AKB 397 BR Program Chart

Typ
Program Chart

Tento návod je vhodný aj pre

AKB 397
5019 100 75058
СХЕМА УСТАНОВКИ
Минимальное расстояние от конфорок: 65 см (электрические
конфорки), 75 см (газовые, керосиновые или угольные)
KARTA INSTALACYJNA
Minimalna odległość od palników: 65 cm (od palników elektrycznych), 75 cm
(od palników gazowych, olejowych lub węglowych)
ÜZEMBE HELYEZÉS
Tűzhelytől való minimális távolság: 65 cm (elektromos tűzhely), 75 cm
(gáz-, olaj- vagy széntüzeléses tűzhely)
INŠTALAČNÁ SCHÉMA
Minimálna vzdialenost' od sporáka: 65 cm (elektrický sporák), 75 cm
(plynový sporák, sporák na naftu alebo uhlie)
POPIS INSTALACE
Minimální vzdálenost od sporáků: 65 cm (elektrické sporáky), 75 cm sporáky
na plyn, naftu nebo uhlí)
КАРТА ЗА ИНСТАЛИРАНЕ
Минимално разстояние от печки: 65 см (електрически печки),
75 см (печки с газ, нафта или въглища)
FIȘA PENTRU INSTALARE
Distanţa minimă de la focuri: 65 cm(focuri electrice), 75 cm (focuri pe bază
de gaze, petrol sau cărbune)
INSTALLATION SHEET
Minimum height above cooker: 65 cm (electric cookers), 75 cm (gas, gas oil
or coal cookers)
RUS
PL
H
SK
CZ
BG
RO
GB
5019 100 75058
AKB 397
5
5
4
4
292
515
1
2
3
6
9
9
7
10
8
8
8
8
A
8:
прикрутите винты
фиксирующих пружин к
корпусу
8:
dokręcić śruby zaczepów
mocujących do
meblościanki wiszącej
8:
rögzítse a rögzítő rugók
csavarjait a konzolos
tetőhöz
8:
pritiahnite skrutky
upevňovacích pružín
8:
přišroubujte šrouby
fixačních pružin k závěsné
skříňce
8:
завинтете винтовете на
затягащите скоби за
закачване
8:
strângeţi șuruburile arcurilor
de fixare la elementul
suspendat
8:
tighten the screws of the
fixing clips to the wall unit
5019 100 75058
AKB 397
1.
Control panel.
2.
Grease filter (inside the extractor grille).
3.
Extractor grille fixing screws.
4.
Lighting unit.
REMOVING AND RENEWING OR
CLEANING THE GREASE FILTER
1.
Unplug the appliance or switch off the mains
power supply.
2.
Remove the extractor grille and unscrew the
fixing screws to access the grease filter.
3.
Remove the device fixing the grease filter.
4.
Remove the dirty grease filter.
5.
After replacing or cleaning the grease filter
(depends on model), remount in reverse
order, making sure the entire extraction
surface is covered.
REPLACING BULBS
1.
Unplug the appliance or switch off the mains
power supply.
2.
Remove the extractor grille and unscrew the
fixing screws to access the bulbs.
3.
Remove the burnt-out bulb.
Use 40W max E14 bulbs only.
4.
Remount the extractor grille.
FITTING OR RENEWING THE CARBON
FILTER
1.
Unplug the appliance or switch off the mains
power supply.
2.
Remove the extractor grille and unscrew the
fixing screws to access the carbon filter
(or the carbon filter location).
3.
Fitting:
Cut off the plastic tab (
c
). Fit the
carbon filter over the motor protection grille -
the reference mark (
a
) on the edge of the
carbon filter should line up with the arrow on
the fan shroud (
b
). Turn clockwise.
Removing:
turn anti-clockwise.
4.
Remount the extractor grille.
CONTROL PANEL
A.
Speed selector.
B.
Light switch.
2
3
1
3
4 4
a
b
c
AB
small amount of steam and fumes
large amount of steam and fumes
a
PRODUCT DESCRIPTION
H SK CZ BGPLRUS GBRO
  • Page 1 1
  • Page 2 2
  • Page 3 3

Whirlpool AKB 397 BR Program Chart

Typ
Program Chart
Tento návod je vhodný aj pre

v iných jazykoch