*OFF MODE

1 2 3 4 5 6 7 8 9 10 11

12 13 14 15 16 17 18 19 20 21 22

32 33 34 35

36 37 38

“Slide Up/Down”

EN Skullcandy, , and other marks are registered

trademarks of Skullcandy, Inc. All rights reserved.

Speaker Driver: 40mm; Impedance: 32 Ohms ●

32 Ohms ● Crusher Driver 34mm; Impédance: 13

Ohms ● THD <0.1% (1mW/500Hz) ● Poids: 275g

• Entrée DC : 5V 500mA. ES Controlador del

Driver 34mm; Impedancia: 13 Ohms ● THD <0.1%

5V 500mA. DE Lautsprecher-Treiber: 40mm;

Impedanz: 13 Ohms ● THD <0.1% (1mW/500Hz)

● Gewicht: 275g • DC-Eingang : 5V 500mA. ZH

(1mW/500Hz) ● : 275g• DC 5V 500

Accoppia Nuovo Dispositivo

Mit Neuem Gerät Koppeln

Muodosta Uusi Laitepari

Le présent appareil est conforme auz CNR d’Industrie

Canada applicables aux appareils radio exemps de

licence. L’exploitation est autorisée aux conditions

suivantes : (1) l’appareil ne doit pas produire de

brouillage, et (2) l’utilisateur de l’appareil doit accepter

tout brouliiage radioélectrique subi, měme si le brouillage

est susceptible d’en compromettre le fonctionnement.

La operación de este equipo está sujeta a las siguientes

dos condiciones: (1) es posible que este equipo o

dispositivo no cause interferencia perjudicial y

the equipment.

The IC Compliance Statement

This device complies with Industry Canada’s

licence-exempt

RSSs. Operation is subject to the following two

(1) This device may not cause interference; and

(2) This device must accept any interference, including

interference that may cause undesired operation of

the device.

operation. This equipment has been tested and found

to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against

harmful interference in a residential installation. This

equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there

is no guarantee that interference will not occur in a

- Increase the separation between the equipment

and receiver.

- Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician

for help.

Domande Visitare il sito: www.skullcandy.com