l) Never place a fan cooled charger in a
place where dust, dirt or similar materials 1. Connect the battery (5) to the charger (1) (see Fig. A).
2. Connect the adapter plug (4) to the charger (1).
can be sucked inside. 3. Connect the adapter (4) to a 110-240 V, 50-60 Hz socket.
m) Under unfavourable conditions, liquid
may escape from the battery; avoid (2)
(3)
contact with the liquid. If the user
accidentally touches the liquid, the place
of contact should be washed with water.
If the liquid gets in the eyes, also seek
medical attention.
n) If you intend to charge more than one
battery in succession, a 30-minute break
should be made between charges.
Explanations of the icons are on the nameplate of the device:
o) Do not open the charger.
p) Do not insert any metal objects into the
charger.
q) After charging, disconnect the battery
charger from the mains and then
disconnect the battery from the charger.
r) In the event of damage to the device,
repairs may only be performed by a
specialised repair facility or a qualified
person in order to avoid hazards.
USE:
The manufacturer is not responsible for damage caused by using the
device not according to its intended purpose or improper handling.
TECHNICAL PARAMETERS:
The charger is designed for charging Li-ion TJ15AK (1,5 Ah), TJ2AK (2
Ah) and TJ4AK (4Ah) batteries.
CHARGING PROCEDURE:
Do the following to charge the battery:
n Battery charging indicator
A green LED light indicates that the charger is connected to a power
source. After the battery is connected, the red LED is on to indicate
charging. Blinking green battery LEDs also indicate that the battery is
charging and show the current battery level.
When the battery is fully charged, the red LED goes off and the green LED
is on.
After charging, disconnect the charger and remove the battery.
NOTE! The battery may get slightly hot when charging. This is not a
malfunction.
The lithium-ion battery can be charged at any moment, without
detriment to its life. Interrupting the charging process does not entail a
risk of damaging the battery cells.
PICTOGRAMS:
PROTECTION OF THE ENVIRONMENT:
NOTE: The symbol nearby denotes that old equipment must
never be thrown away together with other waste (with the
penalty of a fine). Hazardous components of electronic
equipment may adversely affect the natural environment and
human health.
Each household may contribute to the recovery and reuse (recycling) of
old machinery and equipment. Both in Poland and Europe a system for
recovery of used equipment either exists or is being created. The system
obliges all organizations that sell such equipment to collect the used
machinery and appliances. Moreover, general purpose collecting points
for such equipment are available.
MANUFACTURER:
PROFIX Co.Ltd.,
34 Marywilska Street,
03-228 Warsaw, POLAND.
This appliance is in conformity with national and European standards as
well as with general safety guidelines.
NOTE: In case of technical issues, contact an authorised technical service.
Any repairs are allowed to be carried out exclusively by qualified staff with
use of original spare parts.
5
«Read this instruction before switching on the power
supply. »
« »Only for indoor use.
«Class II protection device with double insulation»
«Polarity of the power supply plug»
Input voltage 110-240V
Nominal frequency 50-60Hz
Power consumption 19W
Output voltage 22V d.c.
Charging current 500mA
Equipment class /II
Recommended 20 V Li-ion batteries
Charging time 3-5 hours
TJ15AK(1,5Ah), TJ2AK(2Ah),TJ4AK(4Ah)