10
7 Replace the
filters
The lter replacement light ( )
indicates the lters have to be replaced.
Note
• If you remove the front panel for lter
changing while the purier is switched
on, all lights on the control panel will
be o.
• Once the front panel is placed back to
the purier, all lights ash twice. Then,
the purier is o. Press the
button to
switch on the purier again.
Replace the NanoProtect
Activated Carbon lter
and the NanoProtect
lter
Note
• The NanoProtect Activated Carbon
lter and the NanoProtect lter are not
washable or vacuum cleanable.
Replace both the NanoProtect
Activated Carbon lter and NanoProtect
lter when the
light goes on. This light
will be on for approximately 2 weeks.
On the last day of the 2 weeks, the
purier beeps every 30 minutes to
inform you that the lter needs to be
replaced.
Note
• Insert the lters in the correct position.
• Make sure you place the lters in the
order of NanoProtect lter, NanoProtect
Activated Carbon lter, and nally the
pre-lter.
• Make sure that the side with the tag is
pointing towards you.
1 Switch o the purier and unplug it.
2 Place your ngers in the recesses
of the side panels and gently pull
the bottom part of the front panel
towards you. Lift the panel out of
the hooks at the top of the purier
(g b).
3 Remove the lters using the tag on
the lter. Take the lters by both
sides and gently deposit them into
the house hold trash bin (g s).
Note
• Do not touch the pleated lter surface,
or smell the lter as it has collected
pollutants from the air.
• Wash your hands after disposing of the
used lters.
4 Remove all packaging material
from the new lters (g d).
5 Place the new NanoProtect lter in
the purier rst (g t).
6 Then, place the new NanoProtect
Activated Carbon lter in the
purier (g u).
7 Place the pre-ler in the purier
(g f).
Note
• Make sure that the side with the two
projections is pointing towards you,
and that all hooks of the pre-lter are
properly attached to the purier.
8 To reattach the front panel, insert
the top hooks into the top of the
purier rst (1). Then, push the
panel against the body of the
purier (2) (g g).
9 Reset the NanoProtect Activated
Carbon lter and the NanoProtect
lter lifetime (see ‘Reset the lter
lifetime counter’).