EN-2
1. Read all instructions carefully. Before switching on, make sure that the voltage
of your electricity supply is the same as that indicated on the rating plate on
the bottom of the cleaner.
2. WARNING: Do not use the vacuum cleaner when rug or floor is wet.
Do not use to suck up water.
3. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
4. Children should be supervised to ensure that they do not play with the
appliance.
5. Do not use the vacuum cleaner without a dust bag. Replace the dust bag
before it is full in order to maintain the best efficiency.
6. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette
butts. Keep the vacuum cleaner away from stoves and other heat sources.
Heat can deform and discolour the plastic parts of the unit.
7. Avoid picking up hard, sharp objects with the vacuum cleaner as they may
damage the cleaner parts. Do not stand on the hose assembly. Do not put a
weight on the hose. Do not block the suction or the exhaustion part.
8. Switch the vacuum cleaner off at the machine before unplugging from the
electrical outlet. Do not pull on the cord to disconnect the plug from the
electrical outlet. Ensure that it is disconnected before attending to the filter.
9. The plug must be removed from the socket out-let before cleaning or
maintaining the appliance.
10. The use of an extension cord is not recommended.
11. If your vacuum cleaner is not operating correctly, switch off the power supply
and consult an authorized service agent.
12. If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
13. The vacuum cleaner is provided with a self-resetting thermal cut-out which
automatically shuts off on over-heating. Overheating can be caused by
blockage in the filter, nozzle, tube or hose. After removing the cause and
allowing the motor to cool, the vacuum cleaner will automatically restart.
IMPORTANT SAFEGUARDS
DJ68-00437C(EN)-1 1/14/10 2:22 AM Page 2